Skip to content

Board-Level Micro-Soldering Repair in KPHB, Hyderabad

No PowerShort CircuitsLiquid CorrosionIC ReplacementDead Boards & More

  • ExpertTechnicians
  • 90-DayWarranty
  • No Fix,No Fee
  • KPHBService Center
Close-up of micro-soldering a circuit board with a hot-air tool and precision tweezers

Choose Your Device

Pick your device to see the board faults we repair most on it.

  • MacBook

    Pro, Air & Neo — Intel and M-series

  • iPhone

    iPhone 8 to iPhone 18 Pro & Duo

  • iPad

    iPad, mini, Air & Pro

  • iMac

    21.5, 24 & 27-inch, iMac Pro

  • Mac mini

    Intel and Apple Silicon

  • Apple Watch

    Series, SE & Ultra

Not sure which model you have, or it won't turn on? Send us a photo on WhatsApp and we'll identify it.

Board-level repairs take longer than a part swap — we give you a time with your quote.

Some of the common logic board issues that

We repair

  • Dead Board / No Power

    No lights, no chime, no response. Usually one failed component on a power rail is to blame — we trace it with a thermal camera and multimeter and replace just that part.

  • Short Circuits

    A charger that won't charge, or a board that gets warm while switched off. We find the shorted capacitor or chip and replace it before the damage spreads further.

  • IC & Chip Replacement

    Charging ICs, power-management chips, USB-C controllers and backlight drivers replaced by BGA rework under the microscope, with the rest of your original board left as it was.

A logic board under repair
  • Liquid Corrosion

    Spills leave minerals that keep corroding the board long after it dries. We clean ultrasonically, then rebuild the corroded pads, joints and components.

  • Display & Backlight Faults

    A dark screen with a working Mac underneath, or a display that cuts out. We repair the backlight circuit and display connector on the board, so you may not need a new screen.

  • Boards Others Declared Dead

    Been told you need a new logic board? Bring it in for a free second opinion. Most 'dead' boards come back to life at component level for a fraction of the cost.

4 steps, start to finish

How It Works

  1. 1

    Don't Turn It On

    Keep the device off, remove power if possible and bring it in.

  2. 2

    Ultrasonic Clean

    We clean mineral deposits and corrosion from the board.

  3. 3

    Component Repair

    Shorted or corroded parts are replaced under a microscope.

  4. 4

    Test & Restore

    The repaired device receives a full function test.

FAQ

Board-Level Repair questions

Something not covered here? Call or WhatsApp — we answer honestly, even when the answer is that it isn't worth repairing.

Instead of replacing the whole logic board, we find the single component that failed — a power IC, a capacitor, a corroded connector — and replace just that under a microscope.